THIS SITE IS BEST VIEWED IN GOOGLE CHROME....................................................NOTE: Copyright Issues - Any image on this blog showing Blog's name or Blog address is not claimed to be created by the Blog's author unless otherwise specified.These images have been acquired from the web and Bha Bha Blogsghip bears no copyrights of these images.If you have any objection over any image or content please e-mail to bharatrbh@yahoo.com.

Wednesday, September 1, 2010

How to Calculate Theoretical Plates


Chromatogram sketch
Chromatogram sketch
Chromatography is a method of substance separation. It is implemented using a narrow tube (column) packed with a specific material. A mixture of compounds is forced through the column using pressure. Each compound comes out from the column during certain times, graphically representing a peak on a chromatogram. The position of the peak maximum, called a retention time, is specific for each compound. Performance of chromatographic columns is expressed as a number of theoretical plates. A theoretical plate is an imaginary layer within a column that helps to interpret the separation process. A higher number of theoretical plates corresponds to better column efficacy.




Instructions

Things You'll Need:

  • Calculator
  • Metric Ruler (Vernier Caliper)

  1. 1
    Obtain a chromatogram chart from your chromatographic column.

  2. 2
    Draw a vertical line from the peak maximum to the baseline.

  3. 3
    Measure the length of this line and divide it by 2 to find the center of the line. In these steps, make all measurements in millimeters (mm).

  4. 4
    Draw a line passing through the line's center and parallel to the baseline.

  5. 5
    Measure the length of the line from Step 4 to get the peak width at the half-height. For example, the peak width is 12 mm.

  6. 6
    Measure the distance from 0 to the peak maximum to obtain the retention time. For example, the retention time is 650 mm. Note that the retention time is normally expressed in minutes, but it also proportional to the measured length.

  7. 7
    Divide the retention time by the peak width and raise the quotient in the power of 2. Then multiply the result by 5.55 to calculate the number of theoretical plates:

    Number of theoretical plates = 5.55 * (Retention time / Peak width)^2

    In our example, it would be 5.55 * (650 mm / 12 mm)^2 = 16,284 theoretical plates. The result is rounded to the whole number.




No comments:

Post a Comment

Feel Free to Comment

Top 5 Popular Posts